Cable Protection For Ender-5 Updated

I had a few issues with the Ender 5 cable protection file that most Youtube videos point you to as part of the build. First it wouldn't slice properly in Simplify 3D (left sections missing), then when I finally repaired it I found it was too big for the hole.

So I created this one from scratch. I measured the hole accurately at 30mm x 14.9mm, with a wall thickness of 1.2mm.

For me, on a 0.3mm nozzle, it clicked in nicely. Please leave a comment if this isn't the case with 0.4mm and I'll adjust it.