MakerWorld
Organizers
Zum Modell
Cable Raceway Cover & Channel System (Parametric)
5.7k
Downloads
4.6k
Likes
3.7k
Makes
OverviewOrganize your cords with this 3D printable cable hider system. The set includes straight snap-fit raceways (top and bottom pieces) that are by default 250mm in length, a T-junction, and a 90° bend connector for clean cable routing. The parts are designed to slide or snap securely together while keeping cables accessible. These parts will fit a P1S and larger build plate, and can be scaled up or down as needed to fit additional build plate sizes. ⚠️Caution: This model is intended for interior residential use of low voltage insulated cords / cables or cords that will not generate excessive heat.AssemblyIt's easy to snap the top and bottom parts together, but I've found the even easier option is to slide them together:Place cable in the Bottom channelSlide the Top channel over the bottom channelTip: Offset the top and bottom channel pieces a little to connect consecutive parts. This results in a study and clean mating connection. Connecting BendsConnection bends will snap
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!