Thingiverse
Cable Ring - Organizer
von sternzy
0
Downloads
0
Likes
0
Makes
This ring was designed using a firm TPU filament so the gap is tighter. I wanted something fast to print so I could make many without delay. I have not tested this with other filaments but it works good with TPU. For stronger holder increase the infill with a minimum of 20%. Default quality or better printing is recommended.
Printing:
There are 4 sizes: 5mm, 10mm, 15mm, 20mm
Printing:
There are 4 sizes: 5mm, 10mm, 15mm, 20mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
