Cable Risers for Electric Skateboard

Credit to OKP and UNiK boards for the inspiration for these:

https://www.unikboards.com/en/boutique/riser-pad/

These are for routing motor phase wires and sensor cable neatly to your enclosure. Use 5.5mm bullet connectors, I recommend this style as it give you more room to solder at an angle: http://g01.a.alicdn.com/kf/HTB19wvyQXXXXXasXpXXq6xXFXXXH/1-Pair-Amass-font-b-5-5mm-b-font-Gold-font-b-Bullet-b-font-font.jpg

And to NOT use this style: http://g02.a.alicdn.com/kf/HTB1p3foJFXXXXaWXFXXq6xXFXXXE/100-Pairs-5-5mm-Gold-Bullet-Connector-RC-Motor-Lipo-Battery-Male-Female-Plug.jpg
(Although if your wires fit through the holes in this style it may work too)

You will need to use 12AWG wire and solder at a 90 degree angle BEFORE inserting them into the part from the top. It is a tight fit to keep it sturdy so you may need to use a bit of force to get the bullet connectors in depending on how they print for you and your tolerances.

I have included 2 versions, the Vanguard Bumpe