Cable Spool - Wall / Desk mount

This is simple way to tidy "extra" cables that hang down - if visible cables drive you crazy then this will help! It's designed to be easily mounted via either double-sided tape or a single screw through the center hole. Simply thread your cable through one of the holes on the side, wind around the core and out of one of the holes. The lid is optional and simply screws into the base.

The current model is 75mm wide leaving plenty of space for smaller cables, like USB, Ethernet, coax and smaller power cables, which works for me. If there's demand, I can create a few larger sizes.

It's a simple print and doesn't require any supports, I just suggest you slow down the top layers as the overhangs can cause uneven prints at higher speeds. I print the top layers at ~50mm/s.