Cable Support for Elegoo Neptune 4 Plus

This support system provides clean routing of the extruder cable for Elegoo Neptune 4 Plus. However, it may reduce the maximum available height a bit.

CAN BE USED ONLY WITHOUT THE BIG PART COOLING FAN.

I printed all parts in PETG with the following settings: 0.2 mm layer, 3 walls, 15% infill, 6 top layers, 4 bottom layers, brim. All parts except the bottom require supports, I used tree supports in Cura.

After printing, glue the parts of the middle support together and fix it with two screws. The extruder part is fixed with the existing extruder screws. The bottom support clips into place. Use cable straps to secure the cable on the middle and extruder supports.

Credits: this work is based on or inspired by the following:
https://www.printables.com/model/471314-ender-3-s1-pro-ribbon-cable-support-complete-from-
https://www.printables.com/model/722500-slightly-overengineered-anti-drag-cable-holder-cli
https://www.printables.com/model/866662-neptune-4-max-print-head-cable-chain-mou