Cable to back

switches, controllers, routers, poe switches. Many come with the ethernet connections in the front. Making for a gobbly goop mess of cables.
Print this add between your devices. Leave the mess in the back.

Can be printed in vase-mode/spiralize mode and prints in about 1.5 hours.

settings I used for quick prints not using spiralize mode:
.8mm line width with .4mm nozzle
.3mm layer height
103% flow
75mm/s print speed
4 bottom layers
8 top layers (to compensate for sag)
0% infill
no supports

designed to be glued together for other port devices
can also be scaled in the z direction depending on your needs


ADDED: Closer to double side tape to lower device. Prevents cables moving while positioning and devices moving once set down.

I double side tape the main print to the bottom of the device, put the cables in add 2 closers to each end and where there are cables, put double side tape on the closers then place where I want it on the lower device. This allows me to a