Thingiverse
Cable-tray for Lithophane lampe structure
von arn_3d
4
Downloads
2
Likes
0
Makes
Really likes the Lithophane Lamp Structure by Mafo (https://www.thingiverse.com/thing:1370792) but I thought it was missing the cable management (Got the "before" image in picures) - so I designed a tray to fit my needs there.
The tray have gaps to go around arms inside of the base of the lamp structure. It's a tight fit, just snapped in place - but I added some superglue when assembled just in case.
I've printed this both with and without supports - and it went just fine. Just a tiny cleanup when printed without support with a scalpel-knife.
The tray have a space for a "sugar-cube" for connecting wires. I used a glue-gun to keep everything in place.
When assembling - orient the circle so the outer gap on the tray are on the same side as the cable hole of the base (as shown in the picture).
The tray have gaps to go around arms inside of the base of the lamp structure. It's a tight fit, just snapped in place - but I added some superglue when assembled just in case.
I've printed this both with and without supports - and it went just fine. Just a tiny cleanup when printed without support with a scalpel-knife.
The tray have a space for a "sugar-cube" for connecting wires. I used a glue-gun to keep everything in place.
When assembling - orient the circle so the outer gap on the tray are on the same side as the cable hole of the base (as shown in the picture).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
