Thingiverse
Cactus Passthrough
door Devilish3DPrints
51
Downloads
226
Likes
1
Makes
This is a simple, cactus passthrough! Print for lots of fun!
Filaments used for both the body and spiral: Green PLA by Creality and brown PolyTerra PLA by Polymaker.
**Main settings: **
1) .2mm layer height.
2) A brim is used for the spiral. I used a 5mm brim with a .1mm separation gap.
3) No supports
4) 15% Gyroid infill for both objects.
5) 2 perimeters(walls).
6) Colour change at layer 30.20(if you're following step 1).
The rest of the settings are pretty standard. All you really need is a finely tuned printer.
**If you'd like to support my work, feel free to follow this link: https://buymeacoffee.com/devilish3dprints - your support is very much appreciated :) **
Filaments used for both the body and spiral: Green PLA by Creality and brown PolyTerra PLA by Polymaker.
**Main settings: **
1) .2mm layer height.
2) A brim is used for the spiral. I used a 5mm brim with a .1mm separation gap.
3) No supports
4) 15% Gyroid infill for both objects.
5) 2 perimeters(walls).
6) Colour change at layer 30.20(if you're following step 1).
The rest of the settings are pretty standard. All you really need is a finely tuned printer.
**If you'd like to support my work, feel free to follow this link: https://buymeacoffee.com/devilish3dprints - your support is very much appreciated :) **
Devilish3DPrints publiceert ook op
32 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
