MakerWorld
Decor
Cactus set
by Adam
643
Downloads
337
Likes
307
Makes
Boost MeIf you appreciate the work i do, consider leaving me some boost.Thank you!Flower pot in the second picture.The pot can be inserted into any flower pot you would like, that's why there is only a basic one.The diameter of the pot at 100% is 6cm and the tolerance on the pin is 0.2mm.To make it fit into the flower pot in the second picture I scaled it down to 58%. The fit was quite tight.PrintingOnly cactus_3 needs supports. I used tree supports.Filaments used: Prusament Army green PLA f
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in