Thingiverse
Cactus Stand
di Burrel87
15
Download
18
Likes
0
Makes
To prevent my cacti from tipping over, I designed this stand.
Ring diameter is 51mm, top height is 53mm.
Flip it up side down for printing, no supports needed, angle is less then 45degrees.
Scale up the diameter to fit your pot diameter and scale up the height so the pot is raised up a bit and not resting on the surface you place it on.
Ring diameter is 51mm, top height is 53mm.
Flip it up side down for printing, no supports needed, angle is less then 45degrees.
Scale up the diameter to fit your pot diameter and scale up the height so the pot is raised up a bit and not resting on the surface you place it on.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
