Caddx Turtle V2 - Session Casing

This is a work in progress.. Use at your own risk. :)

This is my attempt to build a casing for the Caddx turtle V2. Its the same size as a GoPro Hero Session.

The idea is that the DVR Board will press fit into the bottom of the casing, The pin will need to go in first though so that the button can be pressed from the outside.

There is a spot for the SD Card on the side.

Steps:
1 - Print all 3 parts
2 - Tap the screw holes in the front of the casing for 3m screws
3 - Insert the small pin into the hole in the bottom of the casing
4 - Press fit the DVR board into the casing with the button and SD aligned to the right parts
5 - Mount the Camera in the arms with 2m screws ( you will probably need longer ones )
6 - Put the pieces together and screw it together with 8mm 3m counter-sunk screws.

Future enhancements I'd like to make
- Cover the SD Card
- Add a battery
- Waterproof... ( not sure how to handle the button, might have to omit it..
- Add room or pri