Cake Pop Disc Tool Egg Shaped

An egg shaped cake pop disc tool. Sizes:Small (Approximately 44mm)Large (Approximately 60mm) Instructions: 1. Place the smaller solid part into the hollow part (as pictured). 2. Place onto the spread out cake mix3. Press it down on the tabs4. Lift the tool up and push the solid part in to pop the cake shape out5. Repeat Care Instructions:Since this is 3D printed please make sure you adequately clean and dry by hand after use to reduce bacteria/germs. See all my cake pop disc tools here: https://makerworld.com/en/collections/7337553-cake-pop-disc-tools