Thingiverse
calibrating cube
von DzMakers
2
Downloads
3
Likes
0
Makes
hi guys
i created the calibration cube and share if you guys like
reason why i create this is because to determine the shrinkage effect of 3d printed object.
the cube is 30mmx30mmx30mm
and there are a shell 10 mm and hole which is 6mm and 3mm
pole 6mm and 3mm
and some overhang
please share if you make one for further improvement !
enjoy !
i created the calibration cube and share if you guys like
reason why i create this is because to determine the shrinkage effect of 3d printed object.
the cube is 30mmx30mmx30mm
and there are a shell 10 mm and hole which is 6mm and 3mm
pole 6mm and 3mm
and some overhang
please share if you make one for further improvement !
enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!