Thingiverse
Calibration ring | 220x220
von DavidHopjan
7
Downloads
6
Likes
0
Makes
CZ : Kalibrace tiskárny o velikosti desky 220x220 mm. Doporučuji velikost vrstvy 0,2 mm. Díky této kalibraci zjistíte nerovnosti na desce popřípadě špatná výška desky.
EN: Calibrating the printer with a plate size of 220x220 mm. I recommend a layer size of 0.2 mm. With this calibration, you will find out any unevenness on the board or poor board height.
EN: Calibrating the printer with a plate size of 220x220 mm. I recommend a layer size of 0.2 mm. With this calibration, you will find out any unevenness on the board or poor board height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
