caliper battery saver

tl;dr print it, bend it, insert it The battery of my cheap caliper dies rather quickly.When I saw https://makerworld.com/en/models/922296#profileId-884615 , i was happy to see a solution. unfortunally I own a slightly different version without the needed opening. Versions:There are two versions of the model. V1 has a simpler geometry with a bigger switch, thats tends to rotate slightly during use.V2 solves the roting issue and is slightly shorter, therefore you can use 150 mm of your caliper instead of 143 mm. Due to the simpler geometry, V1 might be suitable for more caliper-versions than V2.If you havent printed V1 already I would recommend to print both together (still sub 1g of material) and try out witch one fits best. How to install:1. The thin area of the Part has to be bent upwarts to be inserted.2. Remove the battery from the caliper.3. Insert the thin area from the side in a way that it sits on top of the circuit-board.4. Move the printed part into position and reinstall your