Thingiverse
Caliper Connector
par sprout3D
3
Téléchargements
4
Likes
0
Makes
No supports needed.
Please check the attached image to see if it resembles your caliper slot.
The wires are obtained from a FTP cable, the copper section has ~0.5 mm diameter.
The parts have a tolerance of 0.4 mm. If they fit too loose, try increasing the extrusion factor.
I recommend printing at 15 mm/s, 0.4 mm nozzle, 0.2 mm layer height, 50% infill.
Please check the attached image to see if it resembles your caliper slot.
The wires are obtained from a FTP cable, the copper section has ~0.5 mm diameter.
The parts have a tolerance of 0.4 mm. If they fit too loose, try increasing the extrusion factor.
I recommend printing at 15 mm/s, 0.4 mm nozzle, 0.2 mm layer height, 50% infill.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
