Thingiverse
Caliper Guard
von azzar1234
1
Downloads
3
Likes
0
Makes
kept turning my callipers on and off accidentally when putting them in my pencil pot so came up with this and it works perfectly!
super short print
Print vertically and with a skirt as it is just one layer thick
Internal measurements: 4mm wide x 14.5mm and the narrowest part x 25.5mm at the widest part at a 74.5-degree angle.
super short print
Print vertically and with a skirt as it is just one layer thick
Internal measurements: 4mm wide x 14.5mm and the narrowest part x 25.5mm at the widest part at a 74.5-degree angle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!