Caliper holder for FB Ghost 5

Do you often lose a caliper?
I bought a printer to hang a caliper on it xD

This mount is designed to be attached to the standard holes of the printer frame. It is necessary to drill two holes in the removable side plates for the screw m3 and the lower screw m4. Nuts do not need to be used. There is already an M3 thread in the upper hole of the printer frame, and the lower one is used only for coaxial support.

To correctly mark the holes on the side removable plates, take the awl and without removing the plates through the holes from the inside draw the circles of the holes, then remove and drill the holes on the marks.