Thingiverse
Caliper Holder
von NabucodonosorII
3
Downloads
0
Likes
0
Makes
i designed this for my caliper, and ran out of white fillment almost at the end, i hope you enojy this model as much as i enjoyed designing it.
Note: I designed to be used with 3mm thick (on the threaded side) screws, and printed it with a .28 profile at 4% just to see if my desing was functional.
-Nabuconodosor II
Note: I designed to be used with 3mm thick (on the threaded side) screws, and printed it with a .28 profile at 4% just to see if my desing was functional.
-Nabuconodosor II
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
