Thingiverse
Caliper holder
door ROVBOTECH
1
Downloads
1
Likes
0
Makes
A holder for digital or mechanical Caliper. It fits any standard sized caliper.
1) Holder (can be used as is) 1h 10min
2) Large offset (sets holder 40mm away from the wall) 1h
3) Small offset (sets holder 15mm away from the wall) 33min
All trhee can be printed at 0.20 layer heigth and 20% infill
Offsets don't need to be glued.
I recomend without offset or small offset. I was made the offsets only because a friend ask me to.
WARNINGS:
1) follow CURA images in regard to set orientation.
2) Holder needs Supports
3) Offsets don't need supports, but it will need that the layer fan stays ON
1) Holder (can be used as is) 1h 10min
2) Large offset (sets holder 40mm away from the wall) 1h
3) Small offset (sets holder 15mm away from the wall) 33min
All trhee can be printed at 0.20 layer heigth and 20% infill
Offsets don't need to be glued.
I recomend without offset or small offset. I was made the offsets only because a friend ask me to.
WARNINGS:
1) follow CURA images in regard to set orientation.
2) Holder needs Supports
3) Offsets don't need supports, but it will need that the layer fan stays ON
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!