Calluna Peripheral "Foam" Front

This is designed to replace the foam on the left side of the standard case that comes with the Calluna calibration system. The old foam is one piece that simply lifts out. The parts I refer to as “peripheral foam” fit snugly into the place where the old foam as removed. No need to remove any other foam. This is designed to be printed with PETG for heat resistance. I designed this with compartments intended for specific purposes. The long narrow opening in the back is for the Otometrics cavities with the long box-like GSI cavities right on top. The large opening on the right and front is for the printer to sit flat and plugged in all the time. The long opening on the left is specifically designed to fit an iFixit Mako Driver Kit; it can also fit the “Ultimate Adapter Box” I designed for people using the peripheral Calluna foam I designed but not the Calluna topper pieces I designed. The back center opening was designed specifically to hold business cards. The center opening was designed