Thingiverse
CAMARA K1 SUPPORT
door gepigom2883
78
Downloads
78
Likes
1
Makes
This camera support is for Creality K1's camera that, meanwhile is printing, the signal is lost due an overheat.
The original support from Creality is not right because it's too close to heatbed and also the cover doesn't have enough cooling to refrigerate the camera during printing.
Only needs supports in the camera cover. The other doesn't need.
Suitable to print on PETG/ABS but you can do it on PLA also.
Not infill requires.
One M3x20 mm needs to fit the cover with the support. Use the original screws that comes with the camera.
The original support from Creality is not right because it's too close to heatbed and also the cover doesn't have enough cooling to refrigerate the camera during printing.
Only needs supports in the camera cover. The other doesn't need.
Suitable to print on PETG/ABS but you can do it on PLA also.
Not infill requires.
One M3x20 mm needs to fit the cover with the support. Use the original screws that comes with the camera.
gepigom2883 publiceert ook op
38 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
