Thingiverse
Camera Backpack Mount using Manfrotto 200PL quick release plate
0
Downloads
1
Likes
0
Makes
Instead of printing the camera plate, I use the plate come with the Manfrotto ball head.
No support needed.
5 perimeters
0.1mm layer height
print at the angle shown in the image to maximum the strength (I hope so)
I also use two M5 heat set insert inside the Nut cover.
I use 304 stainless steel for the mount bottom.
If anything that is not fit very well, small metal file and sand paper will be your best friend
If like my design, buy me a coffee!
https://buymeacoffee.com/cuckoocuckoo
No support needed.
5 perimeters
0.1mm layer height
print at the angle shown in the image to maximum the strength (I hope so)
I also use two M5 heat set insert inside the Nut cover.
I use 304 stainless steel for the mount bottom.
If anything that is not fit very well, small metal file and sand paper will be your best friend
If like my design, buy me a coffee!
https://buymeacoffee.com/cuckoocuckoo
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
