Camera Desk Stand

This is a small stand which is useful for taking close up pics on a table.

I use it for taking pics of 3D printed stuff ;-)

Its nice and strong in PLA and needs minimal hardware.
I used what I had lying around to design and build mine.

You will need:

2 x 1/4-20 UNC bolt 1" Long For main camera mount
2 x 1/4-20 UNC bolt 1.5" Long For the two tilt mechanisms
3 x 1/4-20 UNC Nuts
1 x 1/4-20 Washer

The pics should give more than enough detail on how it goes together. I used a 6.5mm drill bit to clean up the trough holes.

You will need to print 2 x small thumb wheels and 1 of everything else.