Thingiverse
Camera Handle 1/4 inch thread
von Tuberg555
1
Downloads
0
Likes
0
Makes
A simple handle for your camera, its a 1/4 inch thread so it should work for most cameras.
Note: The thread/screw might break off if you tighten it too much, and i would suggest you go buy a real camera handle as this is only for testing purposes
Note: The thread/screw might break off if you tighten it too much, and i would suggest you go buy a real camera handle as this is only for testing purposes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
