Thingiverse
Camera Hot Shoe/Accessory Mount
by RickiRu
28
Downloads
19
Likes
0
Makes
I needed to mount a light reflector on my video light which had camera accessory places on it - so I made this.
Print both the Mount and the Ring actual size.
The Mount must have support turned on, but the Ring does not need it.
The support just below the thread will need to be removed carefully with a sharp knife - carefully. It is only a couple of mm's thick
The hole through the middle of the Mount is for an M3 pan head screw.
The Mount_Nut is designed for a 3mm nut rather than the head of a screw.
(This mount does not have tripod screw section in the base)
Print both the Mount and the Ring actual size.
The Mount must have support turned on, but the Ring does not need it.
The support just below the thread will need to be removed carefully with a sharp knife - carefully. It is only a couple of mm's thick
The hole through the middle of the Mount is for an M3 pan head screw.
The Mount_Nut is designed for a 3mm nut rather than the head of a screw.
(This mount does not have tripod screw section in the base)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
