Camera Housing

I bought some cheap wireless cameras off of SHEIN a couple years back and just recently had some stuff stolen from outside the house. So needless to say, I had to overcomplicate things and not spend 20$ on amazon.

I needed to make a new housing for one of the cameras. Again, saving money, I repurposed a battery from an old vape. The original battery only lasts about 2 hours, so I swapped the original 200mAh out with an 850mAh battery. And as you guessed, I needed more space to fit it.

The screw holes are for M8 series fine-threaded screws, I used 5/8" length but you can get away with up to 1". If memory serves, the threads are about 26mm deep in total. The overall size of the housing is still compact at 44mmx44mm. For the actual PCB, the mounting holes are not part of the Camera Housing Body STL. Due to the small size of the screws and quality of my printer, I had added some plateaus for the board to sit on and screwed them by hand.


Edit 07/13/2025
A couple different mounts uploade