Thingiverse
Camera Mount for CR-10 Bed
door SummitPA
0
Downloads
0
Likes
0
Makes
This is a slim and narrow center of the bed camera mount. Due to my enclosure having very tight tolerances I couldn't find a camera mount that was tight against the bed.
Some of the parts are a remix of MrMartiniMo design at https://www.thingiverse.com/thing:2600704. I modded his base to sink a M3 nut into it and I'm not using all the parts of his design.
This is designed for a CR-10 /s or any bed that has 239mm on center bed mount screws. It will add 5mm of shim tension to the leveling springs....which I think is a plus. It will not interfere with modded leveling knobs.
Center hole is sized for a M3 screw
This mounts with the leading edge starting pretty close to the end of the bed and is 25mm wide so it will only add about 27mm to your bed depth.
Some of the parts are a remix of MrMartiniMo design at https://www.thingiverse.com/thing:2600704. I modded his base to sink a M3 nut into it and I'm not using all the parts of his design.
This is designed for a CR-10 /s or any bed that has 239mm on center bed mount screws. It will add 5mm of shim tension to the leveling springs....which I think is a plus. It will not interfere with modded leveling knobs.
Center hole is sized for a M3 screw
This mounts with the leading edge starting pretty close to the end of the bed and is 25mm wide so it will only add about 27mm to your bed depth.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
