Camera mount for micro quad (UPDATED)

This is a camera clip to mount a 14mm wide [FPV camera / transmitter module](https://www.banggood.com/CM275T-5_8G-25mW-48CH-NTSCPAL-Mini-VTX-600TVL-FPV-Camera-for-DIY-Micro-FPV-Racer-p-1102464.html?rmmds=search&cur_warehouse=CN) to a 20 x 20mm [flight controller board stack](https://www.banggood.com/Anniversary-Special-Edition-Eachine-Minicube-Flytower-20x20mm-Compatible-Frsky-Flysky-DSM-RX-F3-ESC-p-1179553.html?rmmds=search&cur_warehouse=CN) as sold by BangGood. These are advertised as 20 x 20mm which is the mounting centres of the board. The PCB is actually 25 x 25mm.


UPDATE : I originally had the camera angle at 30 degrees, but my son (whom I made this for) found this was too steep and had to fly too fast to get good forward vision. Accordingly, I've added .stl files for 25 and 20 degrees off vertical.


There is a bit of an overhang in the print - Use support if you need to, or if overheating is causing the shelf to deform put the post in the middle of the arms in your pr