Thingiverse
Camera Mount for Snapmaker
44
Downloads
16
Likes
0
Makes
Remixed from Articualting Raspberry Pi Mount, parts missing here I got from original design. Here you find the Mount and the T-Slut Bolt for the Snapmaker Profiles from the Enclosure for A250/A350.
Print the T-Slut Bolt: Brim, 5-6 Perimeter, 0,08 Layer height
For the Mount Snapmaker Profile 2424: nothing special
The Camera Mount C270: needs a support
Use the nut from original design for the mount. Due to the shrinking I sliced the nut in Cura with 0,2mm "Hole Horizontal Expansion" 5-6 Perimeters because of the thread.
Print the T-Slut Bolt: Brim, 5-6 Perimeter, 0,08 Layer height
For the Mount Snapmaker Profile 2424: nothing special
The Camera Mount C270: needs a support
Use the nut from original design for the mount. Due to the shrinking I sliced the nut in Cura with 0,2mm "Hole Horizontal Expansion" 5-6 Perimeters because of the thread.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!