MakerWorld

Other Tools

Camera screw 1/4" 20 UNC

von Tripo.yt · Other Tools

631 Downloads

161 Likes

396 Makes

IMPORTANT: Do not print in PLA - it is weak material - it can broke. Print it with PET-G, ASA or ABS filament. 've modeled reinforced DLSR camera screw. It has 0,08mm layer height, 100% infill, phase in thread bottom and added tolerances in threads. Full compability with all devices with ¼" 20 UNC mount:CamerasTripodsSport cameras (Gopro and other)DSLRsWebcamsSmall lasers (with ¼" mount) - there are also laser with 3/8" mount so check it before printprototypes of cages and other stuff Print profiles:12.5mm thread length17.5mm thread length22.5mm thread length27.5mm thread length32.5mm thread length42.5mm thread length52.5mm thread length Do not use with very heavy and expensive DSLRs. I've recommended: buy metal one :) This is reinforced screw, but it is rather for lighter devices and prototypes of cages and other stuff. Enjoy!

webcam mount camera screw unc gopro screw gopro screw mount webcam knob gopro camera knob dslr knob photo knob knob tripod accesories tripod tripod accessories tripod accessory tripod action camera screws screw for tripod screw for webcam screw for laser

Kategorie

Other Tools

Quelle

MakerWorld

Veröffentlicht

18.06.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA, ABS, ASA

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Camera screw 1/4" 20 UNC

Ähnliche Modelle

Zur Sammlung hinzufügen