Camera Slider (w/ Inventor files)

A camera slider. Comes in several parts. The camera mounting plate has holes for 1/4" and 3/8". The rods are meant to be 19.3 mm in outer diameter, I used metal railing supports. The rollers are meant to have bearings set in the middle during the print. The bearings are just normal skateboard bearings. The rollers are meant to be attached to the mounting plate with machine screws and nuts. Roller V2 is has a larger hole to accommodate nuts

Supports:
The mounting plate prints well if positioned with the mounting surface flat on the build plate, and supports touching build plate for the hardware insets. The other pieces do not require supports (at your discretion, of course).

Infill:
The rollers should have reasonably high infill; around 50-60% is fine. The mounting plate and end caps can have much less. 5-10% is fine for those.