Thingiverse
Camloc Fastener
von Luscombe8E
27
Downloads
16
Likes
0
Makes
This is a variation of the classic Camloc fasteners.
It is designed for 1/4 inch thick material (lexan) with a 5/8 inch diameter hole. The bushing will snap into the material preventing the button from falling out.
Set up for ~1/4 turn locking with a flat head screw.
Grip length is slightly adjustable with slotted screw mounts on the receptacle
It is designed for 1/4 inch thick material (lexan) with a 5/8 inch diameter hole. The bushing will snap into the material preventing the button from falling out.
Set up for ~1/4 turn locking with a flat head screw.
Grip length is slightly adjustable with slotted screw mounts on the receptacle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!