Thingiverse
Can Cover
von ElectronicKit
448
Downloads
453
Likes
7
Makes
Here is a really simple design for a can cover. It does not keep a gas tight seal on an open can, but keeps stuff from getting in if you are outside or just want to transport an open can in a car, bike ride, etc.
The origin of this idea was taking a can of soda outside to the patio and (not noticing) a wasp dive into the open can.
UPDATED 06/23/2010 - The cover could come into contact with the can\'s contents to some extent, so if there is any question about ABS and food safety - place a piece of plastic food wrap between the cover and the can top.
UPDATED 06/26/2010 - The 'cover275.stl' file added below fits onto a 2.6" DIA. (66mm DIA) can. Layer of food wrap suggested between cover and can top.
The origin of this idea was taking a can of soda outside to the patio and (not noticing) a wasp dive into the open can.
UPDATED 06/23/2010 - The cover could come into contact with the can\'s contents to some extent, so if there is any question about ABS and food safety - place a piece of plastic food wrap between the cover and the can top.
UPDATED 06/26/2010 - The 'cover275.stl' file added below fits onto a 2.6" DIA. (66mm DIA) can. Layer of food wrap suggested between cover and can top.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
