Can Crusher

I haven't actually printed this device yet, but in theory it should be able to handle the force of crushing a can. the weakest point is going to be Lever Arm and Level Arm Connector parts, because they will be experiencing the largest amount of torch.

Please Note:
2 mm Pins - These parts are place holders. The device was designed to Fit a 1.95 mm screw or bolt. The holes are 10 and 6 mm long so as any screw/bolt that fits will work

Can Crusher and Crush Top - There is an Metric M2 tap pattern in the model. If you 3d print this I think you could just fill the holes with hot glue and paint over it. The top piece is for ascetics and doesn't actually effect the functionality of the device