Can Crusher

This is my can crusher project i have been working on. I had an older version that used a manual can crusher taken apart and some random hardware from home depot.

I wanted to make it a bit better after I got a printer so I spent some time learning fusion 360 and created these parts to replace it.

Other things required to complete
- 3x 22x8x7 bearings, I used Amcan 608 ZZ C3.
- 1x 5/16 pin, Mine was about 80mm, don't exceed 88mm. I used [this](https://www.homedepot.ca/product/paulin-5-16-x-36-inch-steel-round-rod/1000126718) and cut it to size, then sanded the sharp edged down on the cut
- 1x 5/16 x 1/2 bolt and a nut/wing nut
- 4x 1/4 x 1 in bolts
-5x 5/16 washers
- 1x [1 1/8 Split Tapered Bushing](https://www.princessauto.com/en/split-tapered-bushings/product/PA1000001199?skuId=8069544).


Motor, Gearbox, and Shaft
1x [60:1 C Face Gear Reducer](https://www.princessauto.com/en/60-1-c-face-aluminum-worm-gear-speed-reducer/product/PA0008607400)
1x 1725 RPM Furnace Motor