Thingiverse
Household
Zum Modell
Can Holder
238
Downloads
520
Likes
6
Makes
A mug/can-holder for your standard 0,5 liter cans like monster-energy cans.
I printed it without supports, it works but there are a couple of spots that need some post prossesing, would recommend using some supports like in the eyesockets and especially the beltbuckle...
otherwise not much to say, there is a lage file (Can Holder Skull.stl) which is the combined file with all components, the other are just the single parts... I split the handle in two so I could place it better on the buildplate. one file (test ring.stl) is included to check the diameter, had a couple of prints that where just a little to tight so for my printer, I scaled it up to 101,5% but just test it out first with the included ring yourself ;)
Happy Printing!
I printed it without supports, it works but there are a couple of spots that need some post prossesing, would recommend using some supports like in the eyesockets and especially the beltbuckle...
otherwise not much to say, there is a lage file (Can Holder Skull.stl) which is the combined file with all components, the other are just the single parts... I split the handle in two so I could place it better on the buildplate. one file (test ring.stl) is included to check the diameter, had a couple of prints that where just a little to tight so for my printer, I scaled it up to 101,5% but just test it out first with the included ring yourself ;)
Happy Printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
