Thingiverse
candle holder
door austinwhlee
4
Downloads
6
Likes
0
Makes
A candle holder with two rings on each side as a decoration. It fits Glimma Unscented tealights from IKEA or similar tealight candles with 1.5 inch in diameter snuggly.
I recommend putting the tealight candle into the top opening and use it as a candle light, then when it is about to run out, you can stick a new candle on by heating up the bottom side of the candle and sticking to the remaining candle wax in the aluminum pan, while it's still placed into the candle holder. The aluminum pan acts as a protection between the 3d printed part made, for instance, by PLA, and a heated wax. I do not guarantee its safety when it's kept lit up for a long time unattended, nor do I have an exact lifetime of the holder when it's in use, so use it with moderate care!
I recommend putting the tealight candle into the top opening and use it as a candle light, then when it is about to run out, you can stick a new candle on by heating up the bottom side of the candle and sticking to the remaining candle wax in the aluminum pan, while it's still placed into the candle holder. The aluminum pan acts as a protection between the 3d printed part made, for instance, by PLA, and a heated wax. I do not guarantee its safety when it's kept lit up for a long time unattended, nor do I have an exact lifetime of the holder when it's in use, so use it with moderate care!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
