Candle wind protector, candle wind shield

This protector would help with: Protecting candle from wind Protecting the candle from collisions Protecting your hand, clothes and floor from melted wax droppings IMPORTANT! - it is highly recommended to print it in PETG due to higher temperature resistance. Although PLA has not been tested, it may work as well but diameter of the cup section need to be increased. Buy me a coffee on Ko-fi: https://ko-fi.com/craftmeng Feel free to share your prints or improvements. I’m very grateful for your likes, boosts, follows and comments, your support is greatly appreciated! Have a wonderful day! Print settings: I found these print settings on 0.5 mm thick and 1 mm thick candle holders work perfect and all layers are consistent: Outer wall width: 0.7 mm Seam position: Back Scarf seam Wall generator: Arachne Wall loops: 1 Infill: 0% Support: no Brim not needed but can be added if it doesn't nicely stick to the bed