Slicer Discord
CANless LED Light Mount – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

CANless LED Light Mount

8 Downloads
2 Likes
4 Makes
Zum Modell
4” CANLess LED light mount I’m finishing my basement, but not the ceiling. I created these brackets to hold CAN-less LED lights by screwing to the floor joists above. I have the HALO brand lights from Home Depot, but probably works with any of the LEDs you can find on Amazon, etc… The mounts bend slightly. I started without (red one pictured hanging) the ring/rim around the perimeter, and recently added to stiffen up without adding too much material/print time (black one). I’m honestly not going to replace the ones I made w/o the ring. The flex isn’t noticeable when the lights are on. Goals:low material usagestarted as a tempoary mount, but I’ll probably just leave these in place. Decided to paint the ceiling.
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Bemalen
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Greg veröffentlicht auch auf

225 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen