canoe-y

With all of the talk about the original benchy boat being pulled, I figured that I'd make a little boat so people could print. I wanted to do a boat, but just ended up doing a canoe. LOL. The model was created completely from scratch not using any geometry from any other models. I have one empty and one with a bench. :) Printing without supports should push your printer to print with > 45 degree overhangs. The very bottom of the boat in the front is the place where the mistakes would show up if it does happen, so when seen from the top sitting on a desk, it still will look pretty good. Just something quick and dirty. Feel free to use/abuse/etc. No license, no attribution and nothing inscribed into the bottom of it. :)