Gadgets
Model downloaden
Canon EF-M Lens Mount Module
368
Downloads
311
Likes
1
Makes
An OpenSCAD module (STL also included) for a Canon EF-M lens mount (the lens side). My initial use for this was to make an adapter to connect my Canon EOS-M camera to a telescope. Hopefully this module is useful to others that want to make custom EF-M adapters.
The design has a recess for the lock pin so it should bayonet and lock like a normal lens. The bayonet fins are tapered slightly for a better fit on the camera and should allow printing without any clean-up. There's also a channel for the electrical contacts so that the mount doesn't push them in too far - I had issues in earlier designs with a pin getting stuck in the pushed-in state. The camera-side of the mount includes a small alignment dot, but I would probably add a more visible dot to whatever is added to the mount.
I was inspired by http://www.thingiverse.com/thing:10829, an EF lens mount, but did not directly use any of the design because EF-M is fairly different. The partial rotate extrude code from http://
The design has a recess for the lock pin so it should bayonet and lock like a normal lens. The bayonet fins are tapered slightly for a better fit on the camera and should allow printing without any clean-up. There's also a channel for the electrical contacts so that the mount doesn't push them in too far - I had issues in earlier designs with a pin getting stuck in the pushed-in state. The camera-side of the mount includes a small alignment dot, but I would probably add a more visible dot to whatever is added to the mount.
I was inspired by http://www.thingiverse.com/thing:10829, an EF lens mount, but did not directly use any of the design because EF-M is fairly different. The partial rotate extrude code from http://
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!