Slicer Discord
Canon EOS lens theft protector – 3D-Druckmodell von Thingiverse Thingiverse

Canon EOS lens theft protector

von RevK
52 Downloads
43 Likes
0 Makes
Zum Modell
It is easy to remove a lens on a Canon EOS camera. Too easy in fact - as I found it whilst queuing in a MacDonald's in St.Petersburg. I sat down to eat a burger and realised I had no lens... Apparently lens theft like this is quite common in Russia!

This covers the lens release button - making it hard to change the lens - using a screwdriver will work, but it is not going to come off by some Russian slight of hand.

This was made for the 24-70 and other lenses look like they need a slightly different design - I may add some other designs later. The 24-70 is the most likely one I would take out where only using one lens, and hence finding this protection useful.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

RevK veröffentlicht auch auf

9 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen