Thingiverse
Canon EOS Screen Hood
von GenesysMedia
7
Downloads
15
Likes
0
Makes
A improved slip on screen hood for the canon eos series cameras, thicker all around
As it is this will fit the r5/r6
If you reduce the model size by 2% in cura it will fit the R7/R50
--Printing Tips--
.3 or .2 layer height recommended (I preferred .3)
Supports - It will need supports, print as laid out, enable supports everywhere with support interface or use the tree mode in cura, both ways work fine.
Printing in black or better yet matte black will get the most amount of shade over the screen
As it is this will fit the r5/r6
If you reduce the model size by 2% in cura it will fit the R7/R50
--Printing Tips--
.3 or .2 layer height recommended (I preferred .3)
Supports - It will need supports, print as laid out, enable supports everywhere with support interface or use the tree mode in cura, both ways work fine.
Printing in black or better yet matte black will get the most amount of shade over the screen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
