Canopy for X Frame Quadcopter

I designed this canopy at the request of a local FPV pilot. It is intended to be printed with a flexible filament (see print settings for more info). The canopy is designed for an X style racing frame. and should work regardless of prop size (4" or 5"). It should work on just about any frame. This canopy comes in two parts:

Part 1: pod_base.stl - this base will fit over a single stack FC/PDB/ESC. It has notches cut out of the corners so wires can fit, and an ESC plug can route out the back.

Part 2: pod_camera.stl - this will fit a runcam swift or similar size camera. Since the sides are flexible, it should accommodate a fairly wide range of cameras. The runcam swift is approximately 24x24mm square, so anything around that size (give or take a few mm) should work. The canopy is also designed to hold an Eachine VTX03. It should fit pretty snug in place and still provide access to press the button.

Instructions:

1. Mount your PDB up with a small spacer. Aim for about 16mm i