Cantilever / Upside Down spool mount (bror)

An upside down spool mount for the IKEA Bror shelf, though I’m sure it will fit most tables and shelves. It can also be used purely using adhesives but I don’t recommend it. Cantilever: stick over a ledge, add some rubber feet or lateral adhesive to prevent movementUpside down with adhesive: Wrap a layer of kapton or regular tape around the base to prevent wall separation and/or sticking to filament wisps⚠️ Ensure that the internal ribs have properly been sliced, slow the printing a bit and raise temperature for better layer adhesion⚠️ The model has been tested for about 15 print hour and 100 hours under static load. The model was also tested with load of 2kg for 1hour under poor leverage there was only mild deflection due to the leverage and no apparent creep (period too short to tell). Even so, I would recommend leaving a safe falling region below