Thingiverse
Cap Face Shield - Covid 19
by HubiDemmel
2
Downloads
1
Likes
0
Makes
These small brackets are a quick way to print a usable faceshield.
You need to print both pieces, then you can use a transparent foil (like for an overhead projector) and just clip them on each side (you can use the foil in portrait or landscape orientation) and then to the shield of your cap.
The overall print-time was about 10min, this is way faster than most other faceshields.
You may need to make the slot for the foil a bit longer, that way it is a bit sturdier.
I´ve included the .step files if you need to change something
You need to print both pieces, then you can use a transparent foil (like for an overhead projector) and just clip them on each side (you can use the foil in portrait or landscape orientation) and then to the shield of your cap.
The overall print-time was about 10min, this is way faster than most other faceshields.
You may need to make the slot for the foil a bit longer, that way it is a bit sturdier.
I´ve included the .step files if you need to change something
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
