Cap for 12x12 microswitch
door AndersSahlman
5
Downloads
1
Likes
0
Makes
As I had a 12x12 microswitch , instead of buying a 6x6 I made a new snapon cap for Eddys excelent leveling switch. The clamp of original design is used as is.
For the switch I have I had to update the config and set the parameter as this:
>Z_PROBE_HEIGHT 9.00
But it of cause depends on the height of microswitch you use.
For the switch I have I had to update the config and set the parameter as this:
>Z_PROBE_HEIGHT 9.00
But it of cause depends on the height of microswitch you use.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!