Thingiverse
cap for the pliers
von hallo_ralph
13
Downloads
14
Likes
0
Makes
here is a cap for the pliers from Wiha Z 36 0 03 135.
this cap only works on this pliers.
insert the pliers the right way round and with a little pressure the cap will snap into place.
this cap only works on this pliers.
insert the pliers the right way round and with a little pressure the cap will snap into place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
